Traceable,NIST,ISO 17025,A2LA,aerosol,anemometers,barometers,battery tester,burn stations,calculators,calipers,carts,clamps,clocks,conductivity,controllers,counters,data logger,desiccants,electrode arm,glassware tools,humidity,lasers,lights,light meters,liquid alarm,magnifiers,moisture,multimeters,oxygen meters,pens,graphs,pressure,vacuum,pumps,slide holder,software,sound meters,stopwatches,tachometers,tags,thermometers,timers,tools,wash bottles,wipes,weather station,pumps,peristaltic  
Home | About Us | Contact | Technical | Dealers | Instructions | MSDS | Order Cat.
Recalibration | Service | Salary Data

Products
Anemometers
Barometers
Battery Tester
Burn Stations
Calculators
Calipers
Carts
Clamps
Clocks
Conductivity
Controllers
Counters
Data Logger
Desiccants
Desiccators
Duster
Electrode Arm
Glassware Tool
Humidity
Lasers
Lights
Light Meter
Liquid Alarm
Manometers
Magnifiers
Moisture
Multimeters
Oxygen Meter
Pens/Graphs
Pressure/Vac
Pumps
Slide Holder
Software
Sound Meter
Stopwatches
Tachometers
Tags
Thermometers
Timers
Tools
Wash Bottles
Wipes
Weather Station
Free Samples
Clamps
Desiccant
Humidity Card
Slide Holder

  4130
  Traceable® Temperature Controller
  • Turn equipment on/off at any temperature
  • Wide Range
  • LCD display shows temperature and time of day
 
Starting at $ 147.08
Specifications: Range is –20 to 60°C and –4 to 140°F · Controls to ±1°C · Controller and relay are 2-3/4 x 5-1/2 x 1-1/4 inches · Weight is 1 pound · 115 VAC, UL-rated relay may be used with equipment to 1800 watts, 15 amps · Sensor cable is 3-1/2 feet  

Traceable® Temperature Controller Complete Description

Turn equipment on/off at any temperature
Controller turns any piece of equipment on or off when temperature rises above “high” set point or falls below “low” set point. Wide setting range of –4 to 140°F and –20 to 60°C permits maintaining temperatures above or below ambient. Control heating elements, cooling blocks, hot plates, heating mantles, cooling systems, or incubators to ±1°C. Controller may be set in 1° increments. Display reads in °F and °C with a 0.1° resolution. Unit accepts standard, three-pronged plug and controls equipment rated to 1800 watts, 15 amps. Brilliant, 1/2-inch-high LCD shows the temperature and time of day to the exact second. Red LED status light indicates on/off mode of attached equipment. Uses the same microchip and software that control sophisticated plant operations. May also be programmed to turn equipment on and off at any minute of any day. “Always-remember” memory permits programming three different pairs of on/off time switchings per day. Memory chip and display are powered by two AAA batteries. Settings are maintained for 1 year in the event of electrical outage.

Learn to operate in seconds
Simple commands are a joy to use. Display walks you through steps. Set high and low temperatures or schedule timer on/off settings in just seconds with press of a few buttons. Manual override permits equipment to be switched on or off instantly without disturbing temperature or timer settings. To assure accuracy an individually serial-numbered Traceable® Certificate is provided from our ISO 17025 calibration laboratory accredited by A2LA. It indicates traceability for temperature only to standards provided by NIST (National Institute of Standards and Technology). Both controller and relay are 2-3/4 x 5-1/2 x 1-1/4 inches and weight is 1 pound. May be used with equipment to 115 VAC, 1800 watts, 15 amps. Temperature sensor cable is 3-1/2 feet in length. Unit is supplied with batteries and a Traceable® Certificate. Replacement battery Cat. No. 1105.

Control Company Cat. No. 4130 Traceable® Temperature Controller

Page updated on